1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the fuel pressure regulator valve connector.
|
3. |
Measure resistance between the fuel pressure regulator valve terminals
1 and 2.
|
4. |
Check that the resistance is within the specification.
|
Parking Brake Assembly Installation
Parking Brake Shoe
1.
Install the shoe hold down pin (A) and spring (B) by pressing
and rotating the spring.
2.
Install the ope ...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Brake Line Removal
1.
Disconnect the brake fiuid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder rese ...