Kia Sorento: Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Emission Control System / Crankcase Emission Control System / Inspection

1.	After disconnecting the vapor hose from the PCV valve, remove the PCV valve.

2.	Reconnect the PCV valve to the vapor hose.

3.

Inspect the PCV vlave operation.

(1)	Run the engine at idle.

(2)	Put a finger on the open end of the PCV valve.

(3)	Make sure that intake manifold vaccum can be felt.

The plunger inside the PCV valve will move back and forth at vacuum.

4.	If the vacuum is not felt, clean or replace the vapor hose.

Schematic Diagram

...

Positive Crankcase Ventilation (PCV) Valve Operation Principle

...

See also:

Front Driveshaft Components
1. Front driveshaft (LH) 2. Inner shaft bearing bracket 3. Front driveshaft (RH) [LH] 1. BJ assembly 2. Clip 3. BJ boot band 4. BJ bo ...

Photo Sensor Inspection
1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lam ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV termina ...

Categories

Copyright © www.ksmanual.com 2014-2026