Kia Optima Manuals

Kia Sorento: Head Lamps Replacement - Lighting System - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Head Lamps Replacement

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Lighting System / Head Lamps Replacement

Bulb (HID)
1.
Turn the head lamp switch off.
2.
Disconnect the power connector from the lamp.
3.
Remove the lamp assembly.
4.
Remove the dust cover.
5.
Remove the ignitor clip (A) from the lamp assembly.
6.
Disconnect the ignitor connector.
7.
Remove the ignitor and bulb (A).
8.
Installation is the reverse of removal.
  
Turn the head lamp switch off to avoid high voltage
Be careful not to damage the bulb and use genuine bulbs only
•
Do not apply excessive force and fit it correctly.
•
Confirm the bulb locking
Bulb (high/low)
1.
Turn the head lamp switch off.
2.
Disconnect the power connector from the lamp.
3.
Remove the lamp assembly
4.
Remove the dust cover.
5.
Turn the bulb socket (A) counterclockwise and then remove it.
6.
Remove the bulb (A) from socket.
7.
Installation is the reverse of removal.
Turn signal lamp
1.
Turn the head lamp switch off.
2.
Remove the lamp assembly
3.
Turn the bulb socket (A) counterclockwise and then remove the turn signal lamp bulb (B).
Ballast
1.
Turn the head lamp switch off.
2.
Disconnect the power connector from the lamp.
3.
Remove the head lamp assembly.
4.
Remove the ballast (A) after loosening the screws (4EA).
5.
Installation is the reverse of removal.
  
•
Turn the head lamp switch off to avoid high voltage.
  
•
HID lamp shall not be used on other cars.(Fire may occur.)
•
Fire may occur when HID lamp initially lights due to the fact that arc-discharge generates high voltage (max. 20,000V) and high current (12-13A), and are different from the halogen lamp specification.
•
Install the dust cover after confirming the locking state between bulb and bulb holder.
•
When testing the HID head lamp, turn the power on or off with switch between power supply and lamp because of high voltage.
•
Do not operate the head lamp switch with the bulb not installed, because it generates spark momently.
Head Lamps Installation
1. Install the head lamp bulbs. 2. Reassemble the head lamp bulb covers. 3. Reassemble the head lamp assembly a ...

Head Lamps Adjustment
Head Lamp Aiming Instructions The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions. ...

See also:

Parking Assist Sensor Installation
1. Install the rear ultra sensor after connecting the connector. 2. Install the rear bumper cover. 3. Connect t ...

Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts (retractor pretensioner and EFD (Emergency Fastening Device)). The pre-tensioner seat belts may be act ...

Occupant Detection system (ODS) Installation
1. Install the ODS equipped seat cushion assembly. (Refer to the Body group- Seat) 2. Install the front passenger seat assembly. ( ...

Categories

Copyright www.ksmanual.com 2014-2026