1. |
Check the bushing for wear and deterioration.
|
2. |
Check the front stabilizer bar for deformation.
|
Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset
/ relearned according to the following procedure.
1.
Check DTC(s) and clear if exist.
...
Blind Spot Detection Unit Inspection
BSD Unit Alignment
To sense the cars exactly in the next lane with the radar, the direction
of the sensor and the direction of the vehicle have to align.
This is BSD unit alignm ...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...