1. |
Loosen the guide rod bolt (B) and then remove caliper body (A).
|
2. |
Replace pad shim (D), pad retainers (C) and brake pads (B) in
the caliper carrier (A).
|
3. |
Compress the piston into the caliper body using the SST (09581-11000).
|
4. |
Place the caliper body (A) on the caliper carrier and tighten
the guide rod bolt (B).
|
5. |
Install the rear wheel & tire.
|
Master Cylinder Components
1. Reservoir cap
2. Reservoir
3. Grommet
4. Master cylinder
...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Components Location
1. Front axle
2. Front lower arm
3. Drive shaft
4. Sub frame
5. Stabilizer bar
6. Steering gearbox
7. Stabilizer link
8. Front strut assembly
...