Kia Sorento: External AMP Repair Procedures - Infotainment System - Body Electrical SystemKia Sorento: External AMP Repair Procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Body Electrical System / Infotainment System / External AMP Repair Procedures

Removal
1.
Remove the luggage floor box.
(Refer to Body - "Rear Transverse Trim")
2.
Disconnect the external amplifier connectors (A).

Body Electrical System — Infotainment System / External AMP / Repair Procedures / Removal illustration

3.
Remove the external amplifier (A) after removing the nuts.

Tightening torque :
1.5 - 2.0 N·m (0.15 - 0.2 kgf·m, 1.1 - 1.4 lb·ft)

Body Electrical System — Infotainment System / External AMP / Repair Procedures / Removal illustration

Installation
1.
Install in the reverse order of removal.
2.
Perform Over The Air (OTA) controller S/W update with KDS.
(Refer to Security and Vehicle Ignition System - "Over The Air (OTA)")
External AMP On Vehicle Inspection
On Vehicle Inspection Diagnostic with KDS 1. The AMP can quickly diagnosed for problems with the KDS. (Refer to "DTC...
Infotainment Jack Repair Procedures
Removal Infotainment Jack 1. Remove the floor console tray. (Refer to Body - “Floor Console Assembly”) ...
See also:

Component Location
1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn (Low pitch) 4. Horn (High pitch) 5. Clock spring ...

Components
2WD 1. Rear upper arm 2. Rear stabilizer bar 3. Rear lower arm 4. Rear assist arm 5. Rear shock absorber 6. Rear cross member 7. Trailing arm ...

Air Conditioner Refrigerant/Compressor Replacement
Refrigerant Recovery/Recycling/Charging/Vacuum/Leak Test (R-134a) Equipped with R-134a recovery/recycling/charging equipment 1. ...

Copyright © www.ksmanual.com 2014-2026 - 0.067