Kia Sorento: ESC Control Module Installation - ESC(Electronic Stability Control) System - Brake System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: ESC Control Module Installation

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module Installation

1.
Installation is the reverse of removal.
2.
Tighten the HECU mounting bolts and nuts to the specified torque.
3.
After installation, bleed the brake system.
(Refer to Brake system - "Brake system Bleeding")
ESC Control Module Removal
1. Turn the ignition switch OFF. 2. Remove the surge tank. [G3.3 GDI] (Refer to Engine Mechanical System - "Surge Tank") ...

Front Wheel Speed Sensor Components
1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

See also:

Water Temperature Control Assembly Removal
1. Disconnect the battery negative terminal. 2. Loosen the drain plug and drain the engine coolant. 3. Remove ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the sensor ...

IPM Components
Outer Connector (L / M / N / K) Connector Pin No. Description Active Remark K 1 IMS LIN     ...

Copyright В© www.ksmanual.com 2014-2023