Kia Sorento: Door Garnish Repair Procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Door Garnish Repair Procedures

Removal

1.

Remove the door garnish nuts (A).

Tightening torque :

1.7 - 2.2 N·m (0.17 - 0.22 kgf·m, 1.2 - 1.6 lb·ft, 14.8 - 19.1 lb·in)

Body (Interior and Exterior) — Body Side Molding / Door Garnish / Repair Procedures / Removal illustration

2.

Remove the front door upper garnish (A), front door garnish (B), and rear door garnish (C).

Body (Interior and Exterior) — Body Side Molding / Door Garnish / Repair Procedures / Removal illustration

Body (Interior and Exterior) — Body Side Molding / Door Garnish / Repair Procedures / Removal illustration

Body (Interior and Exterior) — Body Side Molding / Door Garnish / Repair Procedures / Removal illustration

Body (Interior and Exterior) — Body Side Molding / Door Garnish / Repair Procedures / Removal illustration

Clip position :

Body (Interior and Exterior) — Body Side Molding / Door Garnish / Repair Procedures / Removal illustration

Installation

1.	Install in the reverse order of removal.

Emblem Repair Procedures

Emblem attached area • Standard measurement : Top of emblem from end of tailgate panel (vehicle center) ...

...

See also:

IMS module Removal
1. Remove the negative (-) battery terminal. 2. Remove the front seat assembly. (Refer to Body - "Front Seat") ...

Engine Cover Repair procedures
Removal and Installation 1. Remove the engine cover (A). ...

Engine Control Module (ECM) Removal and Installation
Removal 1. Perform the oil pressure characteristics backup procedure with the KDS when replacing with a new Engine Control ...

Manuals list

Copyright © www.ksmanual.com 2014-2026 - 0.0584