System Outline |
1. |
IGN2
IGN switch input is determined by Local switch “IGN2”.
|
2. |
SEAT MANUAL switch : SEAT Input
|
3. |
SEAT position Sensor (pulse Signal)
Sensing movement amount of Slide, Recline, Front rear height,
and Rear right height motor
|
4. |
“P” Position switch
Sensing “P” position of SHIFT LEVER, not allowed for memory saving
and easy access function by getting on and off a vehicle in the position
other than “P.”
|
5. |
Dr Door switch
This signal is receiver for sensing state of dr door open state
by BCM.
|
6. |
BCM KEY IN
This signal is received for sensing state of KEY by BCM
|
7. |
Local KEY IN switch
This signal is receiver for sensing state of KEY IN state by BCM.
|
8. |
Speed
This signal is received for sensing vehicle speed by BCM
|
9. |
IMS switch
|
10. |
LIN Communication LINE
|
1. |
Input switch - 40ms delay
SLIDE, RECLINE, Front rear height, rear right HEIGHT switch
“P” Position switch, SPEED, KEY IN, LOCAL KEY IN switch, DR DOOR
switch, IGN2 switch
|
2. |
IGN switch input is determined by Local switch “IGN2.
|
1. |
±10%, for TIME without error indication
±50ms, for TIME not exceeding 500ms
|
2. |
Indicated time in each function does not include Time of controlling
CHATTERING started from changing point of rr input.
|
Seat Belt Buckle Switch (BS) Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat assembly. (Re ...
Front Stabilizer Bar Removel
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Head Lamps Inspection
1.
Check-points upon head lamp failure (HID)
(1)
Check the battery voltage. (Low beam will be on when the
battery voltage above 9V.) ...