Kia Sorento: Cylinder Head Cover Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head Cover Removal

1.	Disconnect the battery negative terminal.

2.	Remove the engine cover.

3.	Remove the air duct and air cleaner assembly. (Refer to Intake And Exhaust System - "Air Cleaner")

4.	Disconnect the exhaust OCV (Oil control valve) connector (A).

5.	Disconnect the ignition coil connectors (A) and the fuel pump connector (B), then remove the wiring protector (C).

6.	Remove the ignition coils. (Refer to Engine Electrical System - "Ignition Coil")

7.	Disconnect the fuel hose (A) and PCSV (Purge control solenoid valve) hose (B).

8.	Disconnect PCSV (Purge control solenoid valve) connector (A) and loosen the vacuum & PCSV (Purge control solenoid valve) pipe assembly mounting bolts and nut.

9.	Remove the high pressure pipe (A). (Refer to Engine Control/Fuel System - "High Pressure Fuel Pump")

10.	Remove the high pressure fuel pump (A) and the roller tappet (B). (Refer to Engine Control/Fuel System - "High Pressure Fuel Pump")

11.	Disconnect the PCV (Positive crankcase ventilation) hose (A).

12.	Remove the front engine hanger (A).

13.	Remove the cylinder head cover (A).

Cylinder Head Cover Components

1. Cylinder head cover 2. Gasket ...

Cylinder Head Cover Installation

1. Install cylinder head cover. (1) The hardened liquid gasket sealant located on the upper area between timing chain cover and cyli ...

See also:

Troubleshooting
Symptom Probable cause Remedy play in steering Loose yoke plug Retighten Loose steering gear mounting bolts Retighten L ...

Parking Assist Sensor Installation
1. Install the rear ultra sensor after connecting the connector. 2. Install the rear bumper cover. 3. Connect t ...

A/C Pressure Transducer Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/charging station. 3. ...

Categories

Copyright © www.ksmanual.com 2014-2025