Kia Sorento: Curtain Airbag (CAB) Removal and Installation

Kia Sorento (MQ4, 2021-2026) Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Removal and Installation

Removal

Disconnect the battery negative ( - ) terminal.

After disconnecting the battery negative ( - ) terminal, wait at least 3 minutes and 30 seconds.

2.	Remove the roof trim. (Refer to Body - "Roof Trim Assembly")

3.	Disconnect the curtain airbag connector (A).

Remove the curtain airbag (A) after removing the bolts and nuts.

Tightening torque

Bolt : 7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

Nut : 3.9 - 5.9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft, 34.7 - 52.1 lb·in)

Restraint — Airbag Module / Curtain Airbag (CAB) / Removal and Installation / Removal illustration

Clip position :

Restraint — Airbag Module / Curtain Airbag (CAB) / Removal and Installation / Removal illustration

Installation

Install in the reverse order of removal.

•	Use the color of sentence and line on a airbag to identify curtain airbag.

–	Left side : Yellow label (attached to plastic cover)

–	Right side : Orange label (attached to plastic cover)

•	Be careful not to twist when the curtain airbag installing. The curtain airbag may not deploy normally if twisted.

Check that the airbag system operates normally.

When the IG is on, the airbag warning lamp should turns off after turning on for 3 - 6 seconds.

Curtain Airbag (CAB) On Vehicle Inspection. Curtain Airbag (CAB) Troubleshooting

Curtain Airbag (CAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The center side...

Clock Spring Description and Operation. Clock Spring Troubleshooting

Clock Spring Description and Operation Description The clock spring is a device that transmits the operation signal generated from the sensors installed on the front ...

Kia Sorento: Curtain Airbag (CAB) Removal and Installation

See also:

Manuals list