Kia Optima Manuals

Kia Sorento: Curtain Airbag (CAB) Module Installation - Airbag Module - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Curtain Airbag (CAB) Module Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Tighten the curtain airbag mounting bolts.
Tightening torque
: 6.9 ~ 8.8 Nm (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb.ft)
  
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim. (Refer to the Body group- Interior)
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Curtain Airbag (CAB) Module Removal
1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the roof trim. (Refer to the ...

Airbag Disposal
Special Tool Required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags ...

See also:

Reservoir Tank Removal and Installation
1. Remove the over flow hose(A). 2. Remove the reservoir tank(B) after loosening the bolts. Tightening torque: ...

Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the proced ...

Oil Level Gauge & Pipe Removal and Installation
1. Remove the oil gauge(A). 2. Remove the intake manofold. (Refer to Intake And Exhaust System - "Intake Manifold") ...

Categories

Copyright www.ksmanual.com 2014-2026