Kia Sorento: Compressor Oil Inspection - Air Conditioning System - Heating,Ventilation And Air ConditioningKia Sorento: Compressor Oil Inspection

Kia Sorento (MQ4, 2021-2026) Service Manual / Heating,Ventilation And Air Conditioning / Air Conditioning System / Compressor Oil Inspection

Oil inspection
•
Compressor oil is used to lubricate the compressor.
•
Since the oil circulates into the system during the operation of the compressor, the oil must be replenished to maintain the total capacity of the original oil when replacing the parts in the system or when a large capacity of gas is leaked.

Total capacity of oil in the system
Without rear A/C : PAG 100 ± 10 g (3.5 ± 0.35 oz.)
With rear A/C : PAG 190 ± 10 g (190 ± 0.35 oz.)

Information
Kia Approved : FD46XG (IDEMITSU)
Compressor Oil Handling Tips
•
Prevent moisture, dust and metal particles from entering the oil.
•
Do not mix compressor oil.
•
If the oil is left in the air for a long time after using it, the oil absorbs moisture, so be sure to close the container immediately after use.
Compressor Oil Check and Adjustment
1.
Oil return operation
(1)
Set to maximum cooling, blower speed, and run the compressor for 20 - 30 minutes to restore oil to the compressor.
2.
Before putting oil into the compressor in use, the compressor oil must be checked in the following order.
(1)
Turn off the IG after performing the oil return operation.
(2)
Recover refrigerant by using the refrigerant recovery/recycling/charging machine.
(Refer to Air conditioning System - "Refrigerant Recovery/Recycling/Charging/Vacuum/Leak Test")
(3)
Remove the compressor.
((Refer to Compressor - "Removal and Installation"))
(4)
Drain the compressor oil.
Note
If the drained oil amount is below 70 cc the oil has leaked so perform a leak test.
(Refer to Air conditioning System - "Refrigerant Recovery/Recycling/Charging/Vacuum/Leak Test")
(5)
Adjust the oil level after checking the oil for contamination.
Replacement parts
Adjustment method
higher than 70 cc (2.47 oz.)
Add the capacity of the oil drained.
less than 70 cc (2.47 oz.)
Add 70 cc (2.47 oz.).

Note
•
When exchanging a compressor replenish or drain oil according to the difference in weight between the old and new parts before installing it.
•
When the oil in the air conditioning system is insufficient the durability of the electric A/C compressor deteriorates.
•
If there is a lot of oil in the air conditioning system the performance of the air conditioning system deteriorates.
3.
Oil filling when replacing the parts.
–
Oil replenishment is performed according to the weight difference between the old and new parts.
Information
Perform oil replenishment by referring to the table below if weight comparison is not possible.
Replacement parts
Oil amount [cc (oz.)]
Evaporator core
50 (1.76)
Condenser
30 (1.06)
Receiver drier
30 (1.06)
Suction & liquid hose assembly
10 (0.35)
Discharge Hose
10 (0.35)

Components and Components Location. On Vehicle Inspection
Components and Components Location Component Front Refrigerant Line 1. Expansion Valve1-a. 8.8 - 13.7 N·m (0.9 - 1....
Refrigerant Line Removal and Installation
Removal Suction & liquid hose assembly ...
See also:

On Vehicle Inspection
On Vehicle Inspection Inspection Item • Battery efficiency inspection ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

Starter Components and Components Location. Starter Description and Operation
Starter Components and Components Location Components Location 1. Front Bracket Assembly2. Reducer Assembly3. Yoke Assembly4. Armature Ass ...

Copyright © www.ksmanual.com 2014-2026 - 0.049