Kia Sorento: Camshaft Position Sensor (CMPS) Removal and Installation

Removal

Do not remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flow out engine oil may occur.

Intake

1.	Disconnect the battery negative ( - ) terminal.

2.	Disconnect the Camshaft Position Sensor (CMPS) connector (A).

Remove the CMPS (A) after removing the mounting bolt.

Tightening torque :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Engine Control / Fuel System — Engine Control System / Camshaft Position Sensor (CMPS) / Removal and Installation / Removal illustration

Exhaust

1.	Disconnect the battery negative ( - ) terminal.

2.	Disconnect the Camshaft Position Sensor (CMPS) connector (A).

Remove the CMPS (A) after removing the mounting bolt.

Tightening torque :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Engine Control / Fuel System — Engine Control System / Camshaft Position Sensor (CMPS) / Removal and Installation / Removal illustration

Installation

Install in the reverse order of removal.

•	Install the Camshaft Position Sensor (CMPS) to the specified torque.

•	If the CMPS is dropped, it may cause internal damage. (Do not reuse)

•	Install the CMPS after applying the engine oil to the O-ring (A).

•	Be careful to damage the sensor, when it is installed.

On Vehicle Inspection 1. The engine control system can be more quickly diagnosed for problems with the KDS. (Refer to "DTC guide") ...

Crankshaft Position Sensor (CKPS) Specifications Specification Item Specification Operating vol...

Manuals list