Kia Sorento: Blind Spot Detection Switch Installation

Blind Spot Detection Switch Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") ...

Blind Spot Detection Switch Inspection

1. Disconnect the BSD switch connector. 2. Operate the BSD switch, then check for continuity between terminals of BSD switch connec ...

See also:

Front Body B
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Battery Installation
1. Install in the reverse order of removal. Battery (-)terminal installation nut: 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft) ...

Components Location
Supplemental Restraint System Control Module (SRSCM) Driver Airbag (DAB) / Passenger Airbag (PAB) Side Airbag (SAB) Curtain Airbag (CA ...