Kia Sorento: Battery Removal
| 1. |
Disconnect the battery (-) terminal and (+) terminal (A).
|
| 2. |
Remove the battery mounting bracket (B) and the insulation pad
and then remove the battery (C).
|
| 3. |
Remove the air cleaner.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 4. |
Remove the battery tray (A) after removing the bolts (B).
|
Battery Components
1. Battery insulation pad
2. Battery
3. Battery tray
4. Battery mounting bracket
...
Battery Installation
1.
Install in the reverse order of removal.
Battery (-)terminal installation
nut:
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft) ...
See also:
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Auto Defogging Sensor Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure
and DTC guide. ...
Water pump Components
1. Water pump pulley
2. Water pump
3. Water pump gasket
4. Water pump housing
5. Water pump housing gasket
6. O-ring
7. Water inlet pipe
...
Copyright В© www.ksmanual.com 2014-2023