Kia Sorento: Antenna Coil Removal - Immobilizer System - Body Electrical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Antenna Coil Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body Electrical System / Immobilizer System / Antenna Coil Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A).

3.
Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.

Immobilizer Control Unit Installation
1. Install the immobilizer control unit after connecting the unit connector. 2. Install the crash pad lower panel. ...

Antenna Coil Installation
1. Install the coil antenna and connect the 6P connector. 2. Install the steering column upper and lower shrouds. ...

See also:

Water pump Removal and Installation
1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the dr ...

Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ BSD ...

Direct Electro Hydraulic Actuator Coupling Components
1. Coupling assembly 2. Input shaft 3. Pressure sensor 4. Extension wiring 5. Oil hydraulic Motor(Actuator) ...

Copyright В© www.ksmanual.com 2014-2023