1. |
Loosen the guide rod bolt (B) and then remove caliper body (A).
|
2. |
Replace pad shim (D), pad retainers (C) and brake pads (B) in
the caliper carrier (A).
|
3. |
Compress the piston into the caliper body using the SST (09581-11000).
|
4. |
Place the caliper body (A) on the caliper carrier and tighten
the guide rod bolt (B).
|
5. |
Install the rear wheel & tire.
|
Schematic Diagrams
MDPS Circuit Diagram
Harness Connector
Connector
Pin no
Pin name
Battery
1
Battery +
2
Battery -
Vehicl ...
A/C Pressure Transducer Inspection
1.
Measure the pressure of high pressure line by measuring voltage
output between terminal “1” and “2”.
2.
Inspect the volt ...
Rearview camera (If equipped)
The rearview camera will activate with the ignition switch ON and the shift lever
in the R (Reverse) position.
This system is a supplemental system that shows behind the vehicle through the
rearv ...