Kia Optima Manuals

Kia Sorento: Installation - Inhibitor Switch - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Installation

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch / Installation

1.
Check that the shift lever is placed in the "N" position
2.
Install the inhibitor switch (A).
  
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.

3.
Install the manual control lever (A).
  
Lightly tighten the manual contorl lever nut (B) so that necessary adjustments can be made.

4.
Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).
5.
Tighten the nut (A) and bolts (B) with the specified torque.
Tightening torque:
A : 17.7~24.5 N.m (1.8~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)
B : 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the SST (09480-A3800) from the hole.
7.
Connect the inhibitor switch connector (A).
8.
Install the shift cable by tightening nut (A).
  
Lightly tighten the shift cable mounting nut (A) so that necessary adjustments can be made.

9.
Push the shift cable to the arrow "F" to eliminate free play and then tighten the nut (A) with the specified torque.
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

10.
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
11.
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
Removal
1. Place the shift lever into the "N" position. 2. Remove the air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

Shift Lever Components
1. Shift lever mounting bolt 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

See also:

Ignition Coil Circuit Diagram
...

If the engine will not start
If engine doesn't turn over or turns over slowly 1.If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2.Check the ...

Installation
   • Install the component with the specified torques. • ...

Categories

Copyright www.ksmanual.com 2014-2025