1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
|
2. |
Disconnect the fuel sender connector (A).
|
3. |
Release the fixing hooks, and then remove the fuel sender (A).
|
4. |
Release the fixing hooks (A), and then fuel filter & motor assembly
from reservoir cup.
|
Rear Bumper Components
1. Rear bumper cover
2. Rear bumper lower bracket [RH]
3. Rear bumper lower bracket [LH]
4. Rear bumper side bracket [RH]
5. Rear bumper side bracket [LH]
...
Input Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition (°C)°F
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(0.95 ~ 1.55) 0.950 ~ 1.55
Output voltage ...
Yaw-rate and G Sensor Installation
1.
Remove the ignition key from the vehicle.
2.
Install inthe reverse order of removal.
3.
After installing the ...