Kia Sorento: Towing
If the vehicle needs to be towed, call a professional towing service. Never tow
vehicle with just a rope or chain. It is very dangerous.
[Front]
[Rear]
Emergency Towing
There are three popular methods of towing a vehicle :
- |
The operator loads the vehicle
on the back of truck. This is best way of transporting the vehicle. |
- |
The tow truck uses two pivoting
arms that go under the tires of the driving axle and lift them off the ground.
The other two wheels remain on the ground. |
- |
The tow truck uses metal cables
with hooks on the ends. These hooks go around parts of the frame or suspension,
and the cables lift that end of the vehicle off the ground. The vehicle's
suspension and body can be seriously damaged if this method of towing is
attempted. |
If the vehicle cannot be transported by flat-bed, should be towed with the wheels
of the driving axle off the ground and do the following :
Manual Transaxle
• |
Release the parking brake.
|
• |
Shift the Transaxle to neutral
|
Automatic Transaxle
• |
Release the parking brake.
|
• |
Shift to [D] position, then [N]
position. |
• |
The vehicle equipped
with full-time 4WD should be only transported on a flat-bed. |
• |
Improper towing preparation
will damage the transaxle. follow the above procedure exactly. If
you cannot shift the transaxle or start the engine(automatic transaxle),
your vehicle must be transported on a flatbed. |
• |
It is the best to tow
vehicle no farther than 30km (19miles), and keep the speed below
50km/h (30mph). (For the full-time 4WD vehicle, limit the towing
to 1.5km (1mile) and 15km/h (10mph) |
• |
Trying to lift or tow
your vehicle by the bumpers will cause serious damage. The bumpers
are not designed to support the vehicle's weight. |
|
When heavy rear components such as suspension, fuel tank, spare tire, tailgate
and trunk lid are to be removed, place addition ...
There are five primary symbols used to complement illustrations. These symbols indicate
the part to apply such materials during service.
Symbol
Meaning
Do ...
See also:
Input Speed Sensor Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed senso ...
Rearview camera (If equipped)
The rearview camera will activate with the ignition switch ON and the shift lever
in the R (Reverse) position.
This system is a supplemental system that shows behind the vehicle through the
rearv ...
Head Lamps Component (2)
1. Head lamp assembly
2. Head lamp high beam bulb
3. Head lamp low beam bulb (HID & ignitor)
4. Dust cap
5. Turn signal lamp socket & bulb
...