Kia Sorento: Intake Actuator Replacement - Blower - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Intake Actuator Replacement

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Blower / Intake Actuator Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
3.
Using a screwdriver or remover, remove the crash pad side cover (A).

4.
Disconnect the stopper (B) from the glove box (A).

5.
Disconnect the air damper (A) from the glove box (B).

6.
Disconnect the pins (A) and then remove the glove box (B).

7.
After loosening the mounting screws, then remove the crash pad side garnish [RH] (A).

8.
After loosening the mounting screws, then remove the crash pad under cover (A).

9.
After loosening the mounting screws, then remove the glove box housing (A).

10.
Disconnect the glove box lamp connector (A).

11.
Disconnect the connector (A) and then remove the intake actuator (B) after loosening the mounting screws.

12.
Install in the reverse order of removal.
Intake Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuato ...

Rear Air Conditioner
...

See also:

Cylinder Head Reassembly
   Thoroughly clean all parts to be assembled. Before installing the parts, apply fresh engine oil to all sliding and ...

Hazard Lamp Switch Removal
   • Put on gloves to protect your hands. ...

Pressure Sensor Installation
   • Check the cleanliness of the pressure sensor before installation. ...

Copyright © www.ksmanual.com 2014-2024