Kia Sorento: Evaporator Temperature Sensor Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Evaporator Temperature Sensor Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
|
| 3. |
Remove the heater unit lower case (A) after loosening the mounting
screws.
|
| 4. |
Remove the evaporator sensor (A).
|
| 5. |
Install in the reverse order of removal.
|
Evaporator Temperature Sensor Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure resistan ...
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the resistance ...
See also:
Operation of the rear parking assist system
Operating condition
This system will activate when the indicator on the rear parking assist OFF button
is not illuminated. If you desire to deactivate the rear parking assist system,
press the re ...
Component Location (1)
1. Buzzer
2. Console S/W
3. RKE
4. Anti Pinch Strip
5. Spindle Drive
6. Tailgate Trim Switch
7. Power Latch
8. PTG Control Module
9. Anti Pinch Strip
10. Body ...
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch* fl ...
Copyright В© www.ksmanual.com 2014-2024