Kia Sorento: Blind Spot Detection Unit Installation
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Installation
| 1. |
Install the BSD units to the rear bumper.
|
| 2. |
Install the rear bumper.
|
| 3. |
Connect the negative (-) battery terminal.
|
|||||||||||||
Blind Spot Detection Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
...
Blind Spot Detection Unit Inspection
BSD Unit Alignment
To sense the cars exactly in the next lane with the radar, the direction
of the sensor and the direction of the vehicle have to align.
This is BSD unit alignm ...
See also:
Radiator Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and then
install it on a pressure tester.
2.
Ap ...
Warning Messages
Shift to "P" position (for smart key system and automatic transaxle)
This warning message illuminates if you try to turn off the engine without
the shift lever in P (Park) position.
...
Roof Antenna Installation
1.
Connect the roof antenna connectors.
2.
Install the rear roof trim.
...
Copyright В© www.ksmanual.com 2014-2024