1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the cargo lamp lens (A) with a flat-tip screwdriver.
|
3. |
Remove the cargo lamp bulb (A).
|
4. |
Remove the cargo lamp assembly (A) after disconnecting the connector.
|
Erasing programmed HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be erased):
Press and hold the left and center buttons simultaneously, until the indicator
light begins to flash (approximately 20 ...
Inspection
Lighting Switch Inspection
1.
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is no ...
Rear Driveshaft Components
1. Tone wheel
2. BJ joint
3. BJ boot
4. BJ boot big part band
5. BJ boot small part band
6. Shaft
7. TJ boot small part band
8. TJ boot big part band
9. TJ boot
...