Kia Sorento: Starter Relay Inspection - Starting System - Engine Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Starter Relay Inspection

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Electrical System / Starting System / Starter Relay Inspection

1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay(A).

4.
Using an ohmmeter, check that there is continuity between each terminal.
Terminal
Continuity
30 - 87
NO
85 - 86
YES

5.
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.

6.
If there is no continuity, replace the starter relay.
7.
Install the starter relay.
8.
Install the fuse box cover.
Starter Cleaning
1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation wipe these parts with a cloth only. ...

Cruise Control System
...

See also:

Start/Stop Button Installation
1. Install the start/stop button. 2. Install the start/stop button cover. 3. Install the crash pad lower panel. ...

Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...

Speakers Replacement
Front Speaker 1. Remove the front door trim. (Refer to Body - "Front door") 2. Remove the front speaker (A) after removing ...

Copyright © www.ksmanual.com 2014-2019