Kia Sorento: Speakers Inspection - Audio - Body Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Speakers Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Audio / Speakers Inspection

1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected precisely to remove vibration transmitted from body trims and surrounding parts.

(2)
Case Troubleshooting
No.
Case
Inspection/Remedy
1
Trembling sound
1.
Before replacing the speaker, inspect that the mounting screw is installed normally.
2.
After re-installing the speaker, verify that no trembling sound is heard.
3.
When hearing a trembling sound again, replace the speaker with new one.
2
Noise
1.
Check if the wiring connector is connected normally. If not, reconnect the wiring connector.
2.
In case of radio static, check if there is a noise from CD player.
3.
When a noise is heard on turning radio and CD on, replace the speaker with new one.
  
In case there is only radio static, this causes from poor radio reception. Thus the speaker needs no repair and replacement.
3
Poor working
Inspection of the wiring connection between the battery and the speaker
1.
Before replacing the speaker, inspect the wiring connection between the battery and the speaker is normal.
2.
Check the supplying power to the speaker and the resistance, and then inspect the sound quality.

3.
If the speaker works poorly, replace it with new one.

  
-
During dealing of speaker
-
Do not damage the speaker with impact as like a drop and a throw.
-
Be careful not to cover water and oil over the speaker.
-
Caution during dealing of speaker because the material of diaphragm is paper which is easy to be torn by impact and external force.
-
When modifying audio system as customer pleases, this does electric damage to speaker.
-
And, in this case the speakers are not covered by the manufacturer's warranty.
Audio Unit Installation
1. Connect the audio unit connectors and cable. 2. Install the audio unit. 3. Install the center facia panel. ...

Speakers Replacement
Front Speaker 1. Remove the front door trim. (Refer to Body - "Front door") 2. Remove the front speaker (A) after removing ...

See also:

Engine Control Module (ECM) Adjustment
• After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed. 1) [If installing a used ECM] ...

Refrigeration Cycle
...

TJ Joint Removal
   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

Copyright © www.ksmanual.com 2014-2024