Kia Sorento: Seat Belt Buckle Switch (BS) Installation - SRSCM - Restraint - Kia Sorento XM 2011-2020 Service ManualKia Sorento: Seat Belt Buckle Switch (BS) Installation

Second Generation XM (2011-2020) / Kia Sorento XM 2011-2020 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Installation

  
Be sure to install the harness wires not to be pinched or interfered with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seatbelt buckle & buckle switch.

Tightening torque
Bolt B:
39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb.ft)

4.
Install the front seat assembly. . (Refer to the Body group- Front seat)
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Seat Belt Buckle Switch (BS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Re ...

Occupant Detection system (ODS) Description
In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring electrostati ...

See also:

Front Wheel Speed Sensor Removal
1. Remove the front wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Antenna Coil Installation
1. Install the coil antenna and connect the 6P connector. 2. Install the steering column upper and lower shrouds. ...

General Information
The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the drive ...

Copyright © www.ksmanual.com 2014-2020