Kia Sorento: Photo Sensor Replacement - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Photo Sensor Replacement

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Photo Sensor Replacement

1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from the center of the defrost nozzle after disconnecting the connector (B).

3.
Install in the reverse order of removal.
Photo Sensor Inspection
1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lam ...

Ambient Temperature Sensor Description
The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, ...

See also:

TJ Joint Installation
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Special driving conditions
Hazardous driving conditions When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow extra ...

HID Head Lamp
1. Bulb (1) Elements Xenon gas: Xenon gas activates the initial reaction for rapid illuminating. Molybdenum ...

Copyright © www.ksmanual.com 2014-2019