1. |
Install IPM(Intelligent intergrated Platform Module).
|
2. |
Connect the IPM connector.
|
3. |
Install the crash pad lower panel.
|
Windshield Deicer Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...