Kia Sorento: IPM Function - BCM (Body Control Module) - Body Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: IPM Function

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Body Electrical System / BCM (Body Control Module) / IPM Function

1.
Wiper & Washer Control
(1)
Front Washer Interlocking Wiper Control
If washer switch (WasherSW) is ON at the status of IGN2 ON, Wiper turn ON. If washer switch is OFF, wiper turn ON for 2.5~3.8 seconds and then turn OFF.
(2)
Front Wiper Intermittent Control
If front wiper INT switch is ON at the status of IGN2 ON, wiper turn ON according to INT volume.
(3)
Front Wiper MIST Control
If front wiper MIST switch is ON at the status of IGN2 ON, wiper turn ON continually.
(4)
Rear Washer Interlocking Rear Wiper Control
If rear washer switch is ON at the status of IGN2 ON, Wiper turn ON. If rear washer switch is OFF, rear wiper turn ON for 2.5~3.8 seconds and then turn OFF.
(5)
Rear Wiper Control
If rear wiper switch is ON at the status of IGN2 ON, rear wiper turn ON continually.
(6)
Rear Wiper Intermittent Control
If rear wiper INT switch is ON at the status of IGN2 ON, rear wiper turn ON according to INT volume.
2.
Warning
(1)
Seat Belt Reminder (Front)
ConditionS
Warning Pattern
Seat Blet
Vehicle Speed
Light-Blink
Chime-Sound
Unbuckled
6 seconds
Bucked
6 seconds
None
Bucked → Unbuckled
Below 3 mph
(5 km/h)
6 seconds
None
3 mph
(5 km/h) ~
6 mph
(10 km/h)
6 seconds
Above 6 mph
(10 km/h)
6 seconds on/ 24 seconds off
(11 times)
Unbuckled
Above 6 mph
(10 km/h)

Below 3 mph
(5 km/h)
6 seconds

Stop

(2)
Parking Brake Start Warning
If the vehicle speed is over 5 km/h & parking brake switch ON & IGN ON, the parking brake waring sound is ON.
3.
Rear defogger
(1)
If rear defogger switch turns ON after Alt L is ON while IGN1 is ON, turn the defogger relay output ON for 20min.
(2)
If rear defogger switch turns ON again while defogger relay output is ON, turn the defogger relay output OFF.
(3)
Also turn defogger output OFF in case of Alt L OFF or IGN1 OFF while the defogger relay output is ON.
4.
Power Window Timer
(1)
Turn the safety and power window ECU output ON when turning IGN1 ON.
(2)
Turn safety power window ECU output OFF after keeping safety power window ECU output for 30sec when IGN1 is OFF.
(3)
Turn safety power window ECU OFF immediately when opening the driver door or assist door within the condition (2) above.
5.
Exterior Lamp Control
(1)
Tail Lamp Auto Cut
If the key out and driver door is opened while the key or ACC or IGN ON and tail lamp switch ON, turn the tail lamp relay OFF automatically.
When turning tail lamp switch ON again from OFF after the automatic blackout, the tail lamp relay will be turned ON and Tail Lamp Auto Cut function will be cancelled.
(2)
Auto Light Control
If the value of Auto Light Signal is input value of LIGHT ON at the status of IGN1 ON and the auto light switch ON, turn the light ON in 2.5sec ± 100msec.
If the value of Auto Light Signal is LIGHT OFF and the auto light switch ON, turn the light OFF after 5sec.
(3)
Front Fog Lamp control
Turn the front fog lamp ON when pressing the front fog lamp switch when Head Lamp Low ON.
(4)
Head lamp low control
Turn the head lamp relay ON when turning the head lamp switch ON while IGN1 is ON.
(5)
Escort
Turn the head lamp relay ON for 5 min. when turning the key OFF while the head lamp is ON.
The head lamp relay ON for 15 sec when opening the driver door while the head lamp is ON for 5 min.
The head lamp relay OFF immediately when pressing the door lock button twice with RKE(or FOB) while the head lamp is ON.
(6)
Head Lamp Welcome Function
The tail lamp ON for 15 sec when pressing the door lock button twice with RKE(or FOB) while all doors are closed, locked, the key out and the head lamp switch (or auto light switch) is ON.
If the lock/unlock with RKE(or FOB) or IGN1 & head lamp switch (or auto light switch) OFF while tail lamp ON, the head lamp is OFF.
(7)
Turn Signal Lamp Control
Turn the turn sgnal lamp ON when turning the turn signal lamp switch ON and IGN2 ON.
Triple turn signal operates when the turn signal switch OFF bofore signal lamp operating 3 times.
(8)
Hazard Lamp Control
Turn the hrzard lamp ON when turning the hazard lamp switch ON.
6.
Interior Lamp Control
(1)
Room Lamp Control
If 4 doors are closed & RKE(or FOB) unlocked or 4 doors are closed & KEY ON → OFF, turn the room lamp ON for 30 sec.
If IGN key OFF and door is opend, turn the room lamp ON for 20 min.
If IGN ON while the room lamp ON for 20 min, keep the room lamp ON.
If the door is closed while the room lamp ON for 20 min, keep the room lamp ON for 30 sec.
If the door is locked while the room lamp ON for 30 sec, the room lamp is decaying.
(2)
Room Lamp Auto Cut
Romm lamp turn ON when the ACC and IGN ON.
If ACC OFF, turn the room lamp ON for 20 min.
If vehicle enter the ARMWAIT, the room lamp ON for 3 sec and OFF.
7.
Door Lock/unlock Control
(1)
Central Reminder
Turn the central door unlock ON when the lock inputed while the key OUT and door is opened.
(2)
IGN Key Reminder
Turn the door unlock relay output ON when the knob is locked while the key IN and driver (or assist) door is opened.
(3)
Passive Reminder
Turn the central door unlock ON when receiving the passive unlock signal.
(4)
Crash Door Unlock
Keep the central unlock output for 5 sec when receiving the crash signal while the key IN or ACC ON or IGN ON.
Crash door unlock function has priority to LOCK/UNLOCK control by other functions
(5)
Auto Door Lock By Vehicle Speed Change
All door lock signal is output if vehicle speed is 15km/h when the IGN1 ON and Alt L ON.
(6)
Auto Door Lock By Shift Lever Change
All door lock signal is output if shift lever is changed from P to R/N/D position while the IGN1 ON and all doors are closed.
(7)
Auto Door Unlock By Key In Condition
All door unlock signal is output if the IGN KEY IN→OUT while the door knob is locked.
(8)
Auto Door Unlock By Shift Lever Change
All door unlock signal is output if shift lever is changed from R/N/D to P position while the IGN1 ON and all doors are closed.
(9)
AVN Wakeup Function
AVN wakeup signal is output if door unlock signal is inputed by RKE(or FOB) while the KEY OFF.
(10)
Tailgate Release
Tailgate release relay is ON if tailgate open switch is ON while all door unlocked.
8.
Anti-theft
(1)
If all door is locked with RKE(or FOB) and knob is locked while all door lock and key out, the vehicle enter the ARMWAIT for 30 sec.
(2)
The vehicle enter the ARM after 30 sec from ARMWAIT mode.
(3)
If the door or hood or tailgate is opened in ARM mode, the arlarm is ON for 27sec.
9.
One Touch Triple Turn Signal
Triple turn signal operates when the turn signal switch OFF bofore signal lamp operating 3 times.
IPM Description
IPM (Intelligent intergrated Platform Module) receives various input switch signals ling time and alarm fuctions for fr washer interlocking wiper, fr intermittent wiper, mist wiper, rea ...

IPM Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash pad") ...

See also:

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV termina ...

External Amplifier Installation
External Amplifier 1. Install the external amplifier after connecting the connector. 2. Install the passenger seat assembly. ...

Child-protector rear door lock
\ The child safety lock is provided to help prevent children from accidentally opening the rear doors from inside the vehicle. The rear door safety locks should be used whenever children are in the ...

Copyright © www.ksmanual.com 2014-2019