Kia Sorento: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Circuit Diagram
RemovalCompressor Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the
engine.
The compressor changes low pressure and low temperatur ...
Relay Box (Passenger Compartment) Installation
1.
Install IPM(Intelligent intergrated Platform Module).
2.
Connect the IPM connector.
3.
Install the crash pad ...
Rear Hub - Carrier Disassembly
1.
Remove the hub assembly mounting bolts (A-4ea) from the rear axle
carrier (B).
Tightening torque:
78.5 ~ 88.3N.m (8.0 ~ 9.0 ...