Kia Sorento: Inspection
Lighting Switch Inspection
| 1. |
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch
Lighting switch (Auto light)
Lighting Switch
Dimmer And Passing Switch
Turn Signal Switch
Front Fog Lamp
|
Wiper And Washer Switch Inspection
| 1. |
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
|
Installation
1.
Install the multifunction switch.
2.
Install the clock spring and steering wheel.
3.
Install the steering co ...
Inspection (With GDS)
1.
Check IPM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
See also:
Piston and Connecting Rod Components
1. Piston ring
2. Snap ring
3. Piston
4. Connecting rod
5. Connecting rod upper bearing
6. Connecting rod lower bearing
7. Connecting rod bearing cap
...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the resistance ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026