Kia Sorento: In-car Sensor Replacement - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2025 Service ManualKia Sorento: In-car Sensor Replacement

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).

3.
Disconnect the clock connector (A).

4.
Disconnect the heater and A/C controller connectors (A).

5.
Loosen the mounting 2 screws and then remove the in-car sensor (A).

6.
Install in the reverse order of removal.
In-car Sensor Inspection
1. Turn the ignition switch ON. 2. Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance betwe ...

Photo Sensor Description
The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving ...

See also:

Specifications
Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0) Current va ...

Troubleshooting
Vehicle inspection SYMPTOM CHART Symptom Suspect Area Remedy (See page) Squeak or grunt-noise from the front suspension, occurs more in cold ambient t ...

General Troubleshooting Information
Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Using the battery checker (MCR-570 KIT), check the ba ...

Copyright www.ksmanual.com 2014-2025