Kia Sorento: Heater & A/C Control Unit (DATC) Replacement - Controller - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Heater & A/C Control Unit (DATC) Replacement

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Heating,Ventilation And Air Conditioning / Controller / Heater & A/C Control Unit (DATC) Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).

3.
Disconnect the clock connector (A).

4.
Disconnect the heater and A/C controller connectors (A).

5.
Remove the heater & A/C controller (A) from the center facia after loosening the mounting screws.

6.
Install in the reverse order of removal.
Heater & A/C Control Unit (DATC) Self Diagnosis
1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the ...

See also:

Component Location
1. Hood switch 2. Burglar horn 3. IPM & RF receiver 4. Key warning switch 5. Front door switch 6. Front door lock actuator & switch 7. Rear door lock actuator ...

Direct Electro Hydraulic Actuator Coupling Components
1. Coupling assembly 2. Input shaft 3. Pressure sensor 4. Extension wiring 5. Oil hydraulic Motor(Actuator) ...

Timing Chain Installation
1. Install the balance shaft chain. (Refer to Lubrication system - "Balance Shaft & Oil Pump") 2. Install the crankshaft ...

Copyright www.ksmanual.com 2014-2025