Kia Sorento: Filler-Neck Assembly Installation - Fuel Delivery System - Engine Control / Fuel System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Filler-Neck Assembly Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Installation

1.
Install in the reverse order of removal.

Filler-neck assembly bracket installation nut :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Filler-Neck Assembly Removal
1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation tube quick-connector ...

Accelerator Pedal Removal
1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

See also:

Knock Sensor (KS)
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Rear Stabilizer Bar Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Wiper Switch Washer Switch R ...

Copyright © www.ksmanual.com 2014-2019