Kia Sorento: Drive Belt Removal and Installation
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Timing System / Drive Belt Removal and Installation
| 1. |
For release the tension, turn the drive belt tensioner counterclockwise
then remove the drive belt (A).
|
| 2. |
Install the drive belt (A).
Rotate the drive belt tensioner arm (A) counterclockwise moving the
tensioner pulley bolt with wrench. After putting the belt on the tensioner
pulley, release the tensioner pulley slowly.
Crankshaft pulley → A/C pulley → Alternator pulley → Idler #1 pulley
→ Idler #2 pulley → Water pump pulley → Tensioner pulley.
|
Components
1. Intake camshaft
2. Exhaust camshaft
3. Intake CVVT assembly
4. Exhaust CVVT assembly
5. Timing chain
6. Timing chain guide
7. Timing chain tensioner arm
8. Timin ...
Drive Belt Inspection
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
...
See also:
Front Washer Motor Installation
1.
Reassemble the washer reservoir.
Before installing the pump motor, che ...
Fuel Filler Door Open Switch Inspection
1.
Remove the front door trim panel.
(Refer to Body - "Front door")
2.
Disconnect the switch connector (A) from wiring.
...
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel b ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026