Kia Sorento: Cylinder Block Reassembly
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Cylinder Block Reassembly
| 1. |
Install the oil jet (A).
|
| 2. |
Install the crankshaft.
(Refer to Cylinder Block - "Crankshaft")
|
| 3. |
Install the piston & connecting rod assembly.
(Refer to Cylinder Block - "Piston And Connecting Rod")
|
| 4. |
Install the ladder frame.
(Refer to Cylinder Block - "Ladder Frame")
|
Cylinder Block Inspection
1.
Remove gasket material.
Using a gasket scraper, remove all the gasket material from the top
surface of the cylinder block.
2.
Cl ...
Piston and Connecting Rod Components
1. Piston ring
2. Snap ring
3. Piston
4. Connecting rod
5. Connecting rod upper bearing
6. Connecting rod lower bearing
7. Connecting rod bearing cap
...
See also:
Schematic Diagrams
Circuit Diagram - ESC (1)
Circuit Diagram - ESC (2)
Circuit Diagram - ESC (3)
Circuit Diagram - ESC (4)
ESC connector input/output
Connector Terminal
Specifica ...
Rear Blower Resister Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Ignition Coil Inspection
1.
Measure the primary coil resistance between terminals (+) and
(-).
Standard value:
0.62Ω ± 10%
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026