Kia Sorento: Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs.
|
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Seat belt pretensioner(s)
|
| - |
Driver anchor pretensioner
|
| - |
Front impact sensors
|
| - |
SRS wiring harnesses
|
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Side impact sensor(s) for the crash side(s)
|
| - |
SRS wiring harnesses
|
| - |
Seat belt pretensioner (s)
|
| - |
Driver anchor pretensioner (only rollover crash event)
|
| - |
Turn the ignition switch ON; the SRS indicator should come on
for about six seconds and then go off.
|
Warning Lamp Activation
Components (1)Seat Heater Installation
1.
Install the driver / assist seat heater.
(Refer to Body - "Front seat")
2.
Install the rear seat LH heater and RH heater.
...
Operation
Control Specification
1.
MANUAL Operation
(1)
MANUAL Seat Operation SEAT is to be operated by MANUAL
switch Input of SEAT. SLI ...
Seat belt restraint system
WARNING
For maximum restraint system protection, the seat belts must always be
used whenever the vehicle is moving.
Seat belts are most effective when seatbacks are in the upright position.
...