1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel and reinforce panel.
(Refer to Body - "Crash pad lower panel")
|
3. |
Remove the shower duct (A).
|
4. |
Disconnect the stop lamp switch connector (A).
|
5. |
Remove the brake pedal member mounting nut (A).
|
6. |
Remove the snap pin (A) and clevis pin (B).
|
7. |
Remove the brake pedal member assembly mounting nuts (A) and then
remove the brake pedal assembly.
|
Output Speed Sensor Signal Waveform
...
Installation
•
Install the component with the specified torques.
•
...
Direct Electro Hydraulic Actuator Coupling Inspection
All units are filled up with coupling fluid (ultra-low viscosity
ATF) prior to shipping. Inspection, fill-up, and replac ...