Kia Sorento: Ambient Temperature Sensor Replacement - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Ambient Temperature Sensor Replacement

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Ambient Temperature Sensor Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper")
3.
Disconnect the connector (B) and then remove the ambient temperature sensor (A).

4.
Install in the reverse order of removal.
Ambient Temperature Sensor Inspection
1. Turn the ignition switch ON. 2. Remove the front bumper. (Refer to Body - "Front Bumper") 3. ...

Auto Defogging Sensor Description
The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module rece ...

See also:

Front Fog Lamps Inspection
1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunctio ...

Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P (Park) po ...

Description
The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Acc ...

Copyright © www.ksmanual.com 2014-2019