Kia Sorento: Alternator Installation - Charging System - Engine Electrical System - Kia Sorento XM 2011-2020 Service ManualKia Sorento: Alternator Installation

Second Generation XM (2011-2020) / Kia Sorento XM 2011-2020 Service Manual / Engine Electrical System / Charging System / Alternator Installation

1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical System - "Drive Belt")

Alternator installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Alternator Removal
1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...

Alternator Disassembly
1. Remove the alternator cover (A) using a screw driver after loosening the nuts (B). 2. Remove the slip ring guide (A) and then lo ...

See also:

Components Location
Supplemental Restraint System Control Module (SRSCM) Driver Airbag (DAB) / Passenger Airbag (PAB) Side Airbag (SAB) Curtain Airbag (CA ...

Installation
   Х Install the component with the specified torques. Х ...

Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ BSD ...

Copyright © www.ksmanual.com 2014-2020