Kia Sorento: ESC Control Module Installation
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module Installation
| 1. |
Installation is the reverse of removal.
|
| 2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
| 3. |
After installation, bleed the brake system.
(Refer to Brake system - "Brake system Bleeding")
|
ESC Control Module Removal
1.
Turn the ignition switch OFF.
2.
Remove the surge tank. [G3.3 GDI]
(Refer to Engine Mechanical System - "Surge Tank")
...
Front Wheel Speed Sensor Components
1. Front wheel speed sensor
2. Front wheel speed sensor connector
...
See also:
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Front Body C
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
TJ Joint Removal
•
Special grease must be applied to the driveshaft joint.
Do not substitute with anoth ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026