Kia Sorento: Troubleshooting
| Problem Symptoms Table |
| Symptom |
Suspect Area |
Reference |
| Lower pedal or spongy pedal |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Piston seals (Worn or damaged) 4. Rear brake shoe clearance(Out of adjustment) 5. Master cylinder (Inoperative) |
repair air·bleed replace adjust replace |
| Brake drag |
1. Brake pedal free play (Minimum) 2. Parking brake lever travel (Out of adjustment) 3. Parking brake wire (Sticking) 4. Rear brake shoe clearance(Out of adjustment) 5. Pad or lining (Cracked or distorted) 6. Piston (Stuck) 7. Piston (Frozen) 8. Anchor or shoe (Inoperative) 9. Booster system (Vacuum leaks) 10. Master cylinder (Inoperative) |
adjust adjust repair adjust replace replace replace replace repair replace |
| Brake pull |
1. Piston (Sticking) 2. Pad or lining (Oily) 3. Piston (Frozen) 4. Disc (Scored) 5. Pad or lining (Cracked or distorted) |
replace replace replace replace replace |
| Hard pedal but brake inefficient |
1. Brake system (Fluid leaks) 2. Brake system (Air in) 3. Pad or lining (Worn) 4. Pad or lining (Cracked or distorted) 5. Rear brake shoe clearance(Out of adjustment) 6. Pad or lining (Oily) 7. Pad or lining (Glazed) 8. Disc (Scored) 9. Booster system (Vacuum leaks) |
repair air·bleed replace replace adjust adjust replace replace repair |
| Noise from brake |
1. Pad or lining (Cracked or distorted) 2. Installation bolt (Loosen) 3. Disc (Scored) 4. Sliding pin (Worn) 5. Pad or lining (Dirty) 6. Pad or lining (Glazed) 7. Anchor or shoe (Faulty) 8. Brake pad shim (Damage) 9. Shoe hold-down spring (Damage) |
replace adjust replace replace clean replace replace replace replace |
| Brake fades |
1. Master cylinder (Inoperative) |
replace |
| Brake vibration, pulsation |
1. Brake booster (Vacuum leaks) 2. Pedal free play 3. Master cylinder (Inoperative) 4. Caliper (Damage) 5. Master cylinder cap seal 6. Damaged brake lines |
replace adjust replace replace replace replace |
| Brake Chatter |
Brake chatter is usually caused by loose or worn components,
or glazed or burnt linings. Rotors with hard spots can also contribute to
brake chatter. Additional causes of chatter are out-of-tolerance rotors,
brake lining not securely attached to the shoes, loose wheel bearings and
contaminated brake lining. |
Special Service Tools
Brake SystemDescription
System Operation
Typically, lane departure warning is activated at a speed over 60 km,
but suppressed in case of unintentional lane departure when driver do not operate
turn signal.
S ...
Troubleshooting
Symptom
Suspect area
Engine will not start or stuggle to start
Vapor hose damaged or disconnected
Engine stuggle to start
Malfunction of the Purge ...
Power Seat Control Switch Installation
1.
Install the power seat control switch after connecting the connector.
...