Kia Optima Manuals

Kia Sorento: Front Impact Sensor (FIS) Removal - SRSCM - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Front Impact Sensor (FIS) Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Removal

  
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Disconnect the front impact sensor connector (A).
3.
Remove the front impact sensor mounting bolt (B).
Front Impact Sensor (FIS) Components
...

Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

See also:

Fuel Tank Air Filter Installation
• Install the component with the specified torques. • Note that internal damage may occur when the component is dropped. In this case, u ...

Troubleshooting
Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywhe ...

AC Inverter Switch Removal
   • Pry the trim off using a plastic trim tool and apply protective tape around the rela ...

Categories

Copyright www.ksmanual.com 2014-2026