Kia Sorento: TPMS Sensor Description

|
1. |
Mode
|
(1) |
Configuration State
| A. |
All sensors should be in the Low Line state.
|
| B. |
In Low Line configuration, sensor transmissions
occur every 1 minute (nominal) and pressure is measured
every 4 seconds.
|
|
|
(2) |
Normal Delayed Auto State
| A. |
This is Low Line specific and is used for all
HMC/KMC High Line applications.
|
| B. |
In this state, the sensor will transmit for approx.
12 minutes before automatically entering storage state.
|
|
|
(3) |
Storage Auto State
| A. |
This state is a Low quiescent current state.
|
|
2) |
The sensor does not measure pressure /
temperature / battery level.
|
|
3) |
The sensor will not transmit, unless requested
to do so by the initiate command.
|
|
|
|
(4) |
Alert State
| A. |
The sensor automatically enters this state if
the measured temperature exceeds 110°C and over temperature
shutdown is likely.
|
| B. |
In this state, pressure is measured every 4 seconds
and RF data transmitted every 4 seconds.
|
| C. |
The state lasts for 1 minute if it is pressure
triggered.
|
|
|
Tread Lamp
-
Tire Under Inflation / Leak Warning.
1.
Turn on condition
A.
When tire pressure is below a ...
Tire Removal
1.
Deflate tire & remove balance weights.
...
See also:
BJ Boot Removal and Installation
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...
Starter Cleaning
1.
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will damage the insulation
wipe these parts with a cloth only.
...
Removal
1.
Remove the head lamp.
(Refer to "Lighting system")
2.
Remove the bolts and disconnect the horn connectors, then remove
...