Kia Sorento: Rear Stabilizer Bar Removal
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar Removal
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
In the case of 4WD vehicle, remove the rear differential assembly.
(Refer to Driveshaft and axle - "Rear Differential Carrier")
|
| 3. |
Loosen the nut (A-1ea) and then remove the rear stabilizer link
(B).
[2WD]
[4WD]
|
| 4. |
Loosen the bolt and then remove the rear stabilizer bar (A) with
the sub frame.
[2WD]
[4WD]
|
| 5. |
Installation is the reverse of removal.
|
Rear Assist Arm Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear assist arm for deformation.
...
Rear Stabilizer Bar Inspection
1.
Check the rear stabilizer bar for deformation.
2.
Check the rear stabilizer link ball joint for damage.
...
See also:
Transaxle Oil Temperature Sensor Specifications
▷ Type: Negative Thermal Coefficient Type(NTC)
Temp.(°C)°F
Resistance (kΩ)
(-40)-40
48.1
(-20)-4.0
15.6
(0)32 ...
Component Location
1. Cluster assembly
2. Seat belt switch
3. Vehicle speed sensor
4. Engine coolant temperature sender
5. Oil pressure switch
6. Brake fluid level warning switch
7. Parking ...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025