1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
Remove the sprit pin and castle nut or bolt and then disconnect
the rear assist arm (A) from the rear axle.
[2WD]
[4WD]
|
3. |
Loosen the bolt & nut and then remove the rear assist arm (A)
with the sub frame.
[2WD]
[4WD]
|
4. |
Installation is the reverse of removal.
|
Reservoir Tank Removal and Installation
1.
Remove the over flow hose(A).
2.
Remove the reservoir tank(B) after loosening the bolts.
Tightening torque:
...
IPM Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
...
Rear Glass Defogger Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...