Kia Optima Manuals

Kia Sorento: Propeller Shaft Removal and Installation - Propeller Shaft Assembly - Driveshaft and axle - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Propeller Shaft Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Driveshaft and axle / Propeller Shaft Assembly / Propeller Shaft Removal and Installation

1.
After making a match mark on the flange yoke and transfer companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

3.
After making a match mark on the flange yoke and 4WD coupling companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)
  
Do not reuse bolts.

4.
Install in the reverse order of removal.
  
•
When assembl ying propeller shaft, locate marks on flange yoke and T/M transfer flange to be nearly the same loacation.
Propeller Shaft Components
1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...

Differential Carrier Assembly
...

See also:

Heated Steering wheel Inpection
1. Measure a resistance of NTC and Heated pad. A. NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10% (25°C) ...

Canister Close Valve (CCV)
Canister Close Valve (CCV) is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosphere when leakage detecting syst ...

Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side ...

Categories

Copyright www.ksmanual.com 2014-2026