Kia Sorento: Dynamic Damper Components

TJ Joint Installation

1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Dynamic Damper Removal

1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft�) 2. Remove the TJ joint assembly. (Refe ...

See also:

Wave Form
...

IMS Power Seat Control Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Blower Resistor Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...